 |
 |
|
|
 |
|---|---|---|---|---|
 |
 |
|
|
|
 |
|
|
RESOURCES > EIS > POROUS ELECTRODES
|
|
|
|
Electrochemistry The Bookstore Tell Us !
|
Interest in fuel cells and supercapacitors has lead to renewed attention to porous electrodes.
The figure to the left shows
a schematic for a transmission line model of the de Levie impedance.
The electrolyte resistance through the pore is Ro ohm/cm and the interfacial
impedance is ZIF ohm-cm2. For a small length of the pore, dx, the
electrolyte resistance, dR, and interfacial impedance, dZ are given by the
equations, below. The radius of the pore is r cm, and the resistivity of
the electrolyte is 
ohm-cm. Zo is the impedance at the pore wall-electrolyte interface for a unit
length of pore.
Resources
|
|
If all of the n pores in an electrode are identical (radius r and length l) the equation for ZPORE can be used to obtain the total experimental electrode impedance if the interfacial impedance ( ZIF ) is known (Ref 2).
Barcia, et. al.( Ref 2 ) applied this equation to the cast iron corrosion in water and copper dissolution in HCl. In both cases, fairly complicated models were used for ZIF. They also point out that, although the pores are not all of uniform radius and depth, average radii and depth can be extracted from the EIS data. |
|
|
de Levie showed that the impedance
of a single pore of length l had an impedance given by ZPORE.
This equation holds for any type of interfacial impedance as long as
the interfacial impedance does not depend upon the position in the
pore.
|
|
|
|
|
|
© Copyright
2004 Research Solutions & Resources. |
|||||
 |
|
|
|
 |
|
How useful was
this information? We value your 
